Ships from USA

Driftless Outdoors Trading Co.™

Muzzleloader Setup Guide: What You Need Before the Season

Muzzleloader season is a short window, and the gear needs to be sorted before it opens. In Wisconsin it runs Nov 30 – Dec 9, in Minnesota Nov 28 – Dec 13, and in Iowa the late season runs Dec 21 – Jan 10. This guide covers what a modern in-line needs to shoot well, in the order you'd set it up. It is general guidance. Your owner's manual is the authority on your gun, especially on maximum charge.

Start with your owner's manual

Every muzzleloader has a maximum powder charge, an approved ignition type and recommended projectiles. Read the manual before you buy anything, and never exceed the maximum charge it lists. Use only black powder or an approved black powder substitute. Never load smokeless powder into a muzzleloader.

The five things every load needs

  • Powder: black powder or a substitute such as Triple Seven or Pyrodex, as loose powder or as pellets. Pellets come in set weights, which makes charges consistent.
  • Ignition: most in-lines use a #209 shotgun primer, and some use percussion caps. Buy the type your gun is designed for.
  • Projectile: sabots with a pistol bullet, full-bore conical bullets such as the Hornady Bore Driver, or the projectile your manual recommends. Match the projectile to your barrel's twist rate and caliber.
  • Loading tools: a ramrod with a mark showing seated depth, a bullet starter (a short starter saves your hands), and a powder measure if you use loose powder.
  • Cleaning supplies: patches, solvent and a bore brush. See our cleaning guide.

Sighting in

  • Sight in with the exact load you'll hunt with: same powder, same charge, same projectile and same primer.
  • Shoot groups, not single shots. Change one thing at a time.
  • Fouling changes how the gun shoots. Follow your manual's guidance on cleaning between shots.
  • Confirm your scope is legal for your state's muzzleloader season before you mount it.

Safety basics

  • Treat every muzzleloader as loaded. Keep the muzzle pointed in a safe direction.
  • Keep the primer or cap off until you're ready to shoot, and out of the gun while loading or unloading in the field.
  • Store powder, pellets and primers apart from each other, cool and dry, and away from heat or open flame.
  • Don't smoke or work near open flame when handling powder.
  • Use a ramrod made for your gun.

Federal ammunition rules

ATF notes that ammunition, including shotgun primers, is still subject to Gun Control Act controls, even when the muzzleloader itself is treated as an antique. Persons prohibited from possessing firearms are also prohibited from possessing ammunition, including shotgun primers.

Pre-season checklist

  • Owner's manual read, max charge noted.
  • Powder or pellets in the right type and size.
  • Primers or caps matching your gun's ignition.
  • Projectiles matching your barrel and caliber.
  • Bullet starter, ramrod, cleaning kit.
  • Sighted in with your hunting load.
  • Blaze orange, license and tags.

Frequently asked questions

Q: Can I use smokeless powder in a muzzleloader? A: No. Use only black powder or an approved black powder substitute. Smokeless powder can burst a barrel.

Q: How much powder can I use? A: Follow the maximum charge in your owner's manual and never exceed it. Pellets and loose powder differ in how charges are measured.

Q: What primer does an in-line muzzleloader use? A: Most in-lines are designed for a #209 shotgun primer. Check your manual. Muzzleloader-specific primers are available.

Q: Do I need a special scope or sights? A: Your gun's manual and your state's muzzleloader regulations decide that. Check your state DNR rules before the season.

Sources

Related