Ships from USA

Driftless Outdoors Trading Co.™

How to Clean and Store a Muzzleloader

A muzzleloader that is cleaned right after use shoots better and lasts longer, because black powder and its substitutes leave fouling that attracts moisture. This is general practice. Your owner's manual explains how to remove the breech plug and handle the ignition area on your model, and it takes priority over anything here.

What you'll need

  • Cleaning patches and a jag that fits your caliber
  • A bore brush and a solvent or foaming bore cleaner
  • Rust-prevention patches or a light gun oil
  • A part-soaking cup for the breech plug and small parts
  • A bullet starter and ramrod you already use

Step by step

  • Make it safe. Remove the primer or cap, then confirm the gun is unloaded.
  • Take it apart as the manual allows. Remove the breech plug if your gun has a removable one, and clean it separately.
  • Scrub the bore. Run solvent patches and a brush through the barrel until the patches come out clean.
  • Clean the breech plug and ignition area. Soak small parts, then scrub the threads and clear the flash channel.
  • Dry the bore completely. Run clean dry patches until they come out dry.
  • Protect the metal. Run a rust-prevention patch or lightly oiled patch through the bore and wipe the exterior.
  • Reassemble following the manual, and keep the primer out of the gun until you're ready to shoot.

Before the hunt

Wipe oil out of the bore before you load, as your manual directs, so it doesn't contaminate the powder charge or the primer. Then confirm the gun shoots to point of aim with your hunting load.

Storing the gun

  • Keep it in a dry place, in a case that lets air move.
  • Store powder, pellets and primers separately, cool and dry, away from heat and flame.
  • Check the bore for rust at the start of each season.

Stock list

  • Foaming bore cleaner and solvent
  • Rust-prevention patches
  • Cleaning patches in 2 in. and 500-count packs
  • Cleaning jags and bore brushes
  • A bullet starter such as the CVA Knuckle Saver

Frequently asked questions

Q: How often should I clean a muzzleloader? A: After each shooting session or hunt, because fouling holds moisture and causes rust.

Q: Can I use any solvent? A: Use a solvent made for muzzleloaders or the one your manual recommends.

Q: Do I clean the breech plug? A: Yes, if your gun has a removable one. Clean the threads and flash channel as your manual directs.

Q: Should I leave oil in the bore? A: Wipe the bore dry before loading, as your manual directs. Oil in the bore can foul the powder.

Sources

  • Manufacturer owner's manuals govern disassembly, breech plug and ignition-area cleaning for each gun.
  • General cleaning practice; no web sources cited. Review against your owner's manual before publishing.

Related